Zone of inhibition measurement
Hygiene quick tests
Sterilization of inoculation loops
Manual and automated colony counters
Rapid Microbiological Methods
Offline cell counters for breweries
Sample bags and holders
ELISA tests for pathogenic bacteria in food
Sterile sampling, dilution aid and media
Work stations (hypoxic)
Work stations (anaerobic, microaerophilic)
Hypoxic Workstation for Stem Cells
Live Cell Imaging and Fluorescence Microscopy
Optimization of immune and stem cells
Portable Incubation Box
Rapid DNA typing
Equipment for Bioreactors
Online Sampling-Modules for Bioreactors
Filtration and Chromatography
High-Pressure Cell Disruption
Cell-Retention Devices, Systems for Perfusion
Proteomics Analysis sample preparation
Shaker and Shakeflasks
Manufacturer: IUL Instruments S. A.
Automating slide staining is a must for labs that wish to increase their yield. The PolyStainer performs standardized staining procedures that free lab staff from labor-intensive staining procedures. General microbiology and histology labs that seek to reduce sample staining workloads will greatly benefit from its use.
Up to 20 microscope slides are loaded in the PolyStainer basket. Next the robotic arm will dip and stir these through four exchangeable plastic wells. Slides can be dipped in a fifth drainable water well that ensures water will be renewed after rinsing each slide basket. Last, slides can be fan dried with or without heat. The four reagent wells in the system allow to perform an extremely broad array of stains.
Walkaway Solution: A one push button operation triggers the entire staining procedure.
Unique Design: The PolyStainer was uniquely designed to separate its staining area from the system’s electronics and mechanics, this ensures endurance due to separation from highly oxidative reagents.
Staining Protocol Optimization: Ensures no cross contamination by using the PolyStainer’s rinsing well drain to keep rinsing water clean. Speeds stain preparation by drying out slides.
Slides / Basket: 20 slides each basket
Basket Lifting Motor: 2.6W 12V /c 141:1 /encoder
Carriage Movement Motor: 1.65W 12V / 28:1 / encoder
Heater: 12ºC-15ºC higher that the room temperature
Heater Air Pressure: 80 Pa
Air Volume: 30 m3/h
Water Control: Electro valve 4W 24V IP65
Water Flow Program: Permanent/Autoiniciated at previous bath
Water Pressure: 2bar / 6bar (instrument supplied with three different manifold)
Optional Output: RS232
Dimensions (WxHxD): 70x40x34
Reagent Containers: Polyethylene
Basket Holder: Stainless Steel AISI 304
Basket: Stainless Steel AISI 304
Additional connections for peripherals: 2 x USB Host ports
Programming Memory: 10 programs - 10 steps per program.